Leister GEOSTAR G5 Instructions D'utilisation page 47

Working display overview
Readiness
Standby mode is activated.
If the engine is switched
o , the heating activated
and if no button is ac-
tivated during the time
defi ned under "Standby
interval", then the device
will switch over automati-
cally into Standby display.
If the "e-Drive"
is not
pressed during the subse-
quent 180 seconds, then
the heating will shut o au-
tomatically. "Standby" will
then appear afterwards
on the display. Pressing
"e-Drive" causes the
device to switch to Work-
ing mode.
Standby mode is deacti-
vated in the factory set-
tings.
Gear Ratio Drive
The value (slow/fast) must
match the sprocket wheel
arrangement in the gear-
box. Chapter "Change
gear speed"
Show Duty Info
Hours Drive:
Current running time of the
drive
Hours Heating:
Current running time of the
heater
Hours Machine:
Current running time of the
machine
Day Distance:
Currently traveled distance
(can be reset)
Total Distance:
Total distance traveled.
Show General Info
Firmware HMI:
Software version of the
display unit
(communication module).
Firmware Machine:
Software Revision
Production Info:
Information on date of
production and production
number
Warning display
If there is a warning pend-
ing, this is indicated by the
symbol in the status
display. The "Warnings"
menu contains more de-
tailed information about
the current warning.
47