Leister GEOSTAR G5 Instructions D'utilisation page 45

Function and working display
Function display (34)
Symbol
160
°C
380
390
°C
380
385
°C
380
380
°C
Meaning
Drive speed [m/min / ft./min]
Drive speed blocked [m/min / ft./min]
Welding wedge temperature [°C/°F]
Welding force [N/lbs]
Information box
Devices in Standby mode. The heating is switched o after the counter runs
through.
An error has occurred. An error code also appears
(the device is no longer ready for use). Contact an authorized service center.
See Chapter "Warnings and Error messages"
Warning:
See Chapter "Warnings and Error messages"
The arrow pointing upward and the progress bar indicate that the setpoint
(shown on the progress bar) has not yet been reached (too cold). The fl ashing value
is the actual value. The value next to the progress bar is the setpoint.
The arrow pointing downward and the progress bar indicate that the setpoint
(shown on the progress bar) has not yet been reached (too hot). The fl ashing value
is the actual value. The value next to the progress bar is the setpoint.
If "Show Set Values" is activated, both the actual temperature (large font size) and
the set temperature (small font size) are displayed. Default setting ex-works.
If "Show Set Values" is deactivated, then only the actual values (large) are dis-
played during operation, otherwise only the setpoint values (large).
45