2.8
TOOL MENU
It is possible to go from the Setting menu to the Tool menu. Under the Tool menu you can access the control panel's
other functions, which are described in chapter 2.9 Tool menu - functions.
72.0°
F
2 kW
2.9
TOOL MENU – FUNCTIONS
When your are in the Tool menu, you can use the tools described below. Step between the various tool fields by
pressing the up or down arrow symbols. You can always leave the Tool menu by pressing the MENU button.
NOTICE
Functions marked with an asterisk (*) indicate that the symbol for the function is displayed on the control panel
even if the accessory function is not installed.
1
2
3
Settings
8
7
6
1. Night automation
Automatically changes certain functions
during the night. This can be set to take place
every night or on specifics nights of the week.
The functions that can be changed are:
•
Temperature
•
*Change of room sensor
•
Turn off warm water
2. Day automation
Automatically changes certain functions, e.g.
if you are away for a while during the day.
Select that it takes place every day or a spe-
cific day each week. The functions that can
be changed during the day are:
•
Temperature
•
Turn off hot water
Functions marked with a (*) are accessories, which are not installed on all vehicles, refer to the vehicle manufacturer's
instructions.
1. Press the tool symbol to access the Tool menu.
4
9
10
11
Settings
°C
°F
5
13
12
14
15
16
Settings
19
18
17
3. Prio setting
With this function you can choose to prioritise
(select) electricity or gas as the main alterna-
tive
4. Clock
The clock must be set if you want to use the
timer for the engine heater, the night and/
or day mode or automatic start with a timer.
If 12V power is lost, the clock will stop and
will no longer be displayed. Installing battery
backup*
(Art. No. 3010 420)
from happening.
5. Return
Press this symbol to return to the previous
menu.
20
21
22
Settings
24
23
will help prevent this
19