From Standby Mode To The Setting Menu; Set The Required Temperature; Domestic Hot Water - Alde Compact 3020 Instructions D'utilisation

2.3

FROM STANDBY MODE TO THE SETTING MENU

When in standby, the indoor temperature is displayed and the outdoor temperature is displayed if an outdoor tem-
perature sensor has been connected. The background lights up when you press the screen or the MENU button. Start
the Setting menu by pressing the MENU button. The background lights up and those functions which can be set are
displayed. The settings are automatically saved after 10 seconds. The control panel reverts to standby automatically
after 30 seconds if no buttons are pressed (or if the MENU button in the Setting menu is pressed).
1. The control panel in standby
72.0°
F
43.0°
F
Fri 6:30 am
2.4

SET THE REQUIRED TEMPERATURE

The temperature can be set from +41 °F/+5 °C to +86 °F/+30 °C in steps of 1 °F/0.5 °C. Hot water is always available
when the boiler is on and running on LP Gas and/or electricity.
72.0°
F
2 kW
2.5

DOMESTIC HOT WATER

There are three different alternatives for regulating the heating system depending on the need for hot water: no hot
water, normal operation and extra hot water.
72.0°
F
2 kW
2. The control panel in setting menu.
1. The temperature displayed is the temperature which is set at present
(in this case 72 °F/22 °C).
2. Raise the temperature by pressing the + button. Lower the tempera-
ture by pressing the – button.
3. The settings are ready and the central heating will circulate at the set
temperature.
1. No hot water. If hot water is not needed, press the "-" button.
(the symbol is empty)
If night or day automation is activated, see 2.9, sections 1 and 2 and
when hot water is turned off, it is not possible to make hot water
adjustments. The plus and minus symbols are then gray.
72.0°
F
2 kW
17