Troubleshooting - Alde Compact 3020 Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1.14 TROUBLESHOOTING

Always start by checking any fault messages in the control panel. If a fault occurs in the system, the cause will be
shown on the display. This is only displayed when the control panel is in standby mode.
(See chapter 2.11 Fault messages)
• THE HEATING SYSTEM DOES NOT START ON GAS
1. Check to make sure that there is gas in the LP Gas tank. If it is empty, have the tank refilled.
2. Check to make sure that the main gas valve is fully open. If not, open the gas valve all the way.
NOTICE
If the heating system has not been operated for some time, or if the gas cylinder has been changed, it may take
longer than normal to light the LP Gas burner in the boiler.
Check that the boiler is connected to the electricity supply (> 11 V DC)
3. Check that the 12V fuse for the boiler is intact.
4. Check whether the electric connections on the boiler are securely in position.
If none of the above helps, contact a service workshop.
• THE ELECTRIC HEATING ELEMENT IS NOT WORKING
WARNING
SHOCK HAZARD
VARNING
The 120V ~ electrical service presents a risk of electrical shock. Do not attempt to service the electric heat-
AVERTISSEMENT
ing element yourself.
WARNUNG
1. Check that there is an electricity supply (120V ~) to the vehicle.
ADVARSEL
2. Check that the relays fitted to the boiler come on (a slight click can be heard from the relays when the heating
element is switched on at the control panel).
VAROITUS
If none of the above helps, contact a service workshop.
ADVERTENCIA
AVVERTENZA
WAARSCHUWING
14

Publicité

Chapitres

Table des Matières
loading

Table des Matières