Commissioning; Before Commissioning - GOLDSCHMIDT GP 4000 Notice D'utilisation

Figure 20: Operating and adjustment controls for
diesel engine 3
Figure 21: Operating and adjustment controls for
diesel engine 4
Control element Function
Starter handle To start the engine with a
recoil starter.
Decompression
To reduce the force required
lever for engine start.
Throttle lever To adjust the engine speed
and therefore the rotation
speed of the grindstone.
Fuel tap
To adjust the fuel feed
(2 states: "open" and "closed").
Oil fill plug Support the starting process
at cold start.
The numerals of the control
NOTE
elements in the following sub-
sections relate to the previous
pictures in this chapter.
6.2

Commissioning

6.2.1 Before commissioning

Always check the general state of the machine before
commissioning:
1. Check the outside and the underside of the engine for
signs of oil or fuel leaks.
2. Remove excessive dirt or foreign bodies, in particular
near to the muffler and the recoil starter.
3. Look for signs of damage on the engine, e.g. cracks
and breaks.
4. Check the external condition of the power cable
(for wear, loosened connections, blank wires).
5. Check if all guards and covers are fitted and all nuts
and screws have been tightened.
6. Check grindstone for suitability of use and replace
if necessary.
7. Check engine oil level.
If the engine is not in perfect condition, do not start the
engine. Instead carry out maintenance or inform the repair
personnel.
Check the engine for fuel and consumables before each
operation:
1. Check the fuel level regularly and fi ll in fuel as necessary.
For this please see chapter 6.6.1 "Check and fill in fuel"
on page 27.
2. Check the engine oil and fill in oil as necessary.
For this please see chapter 6.6.2 "Check and fill in engine
oil" on page 29.
3. Check the air filter element and clean or replace as
necessary. For this please see chapter 6.7 "Check and
clean the air filter element" on page 30.
23