Long Term Storage - Nanni N2.10 Notice Et Mode D'emploi

Long term
storage
A set of operations must be per-
formed to prepare and protect the
engine for a long-term storage.
Refer to the corresponding chapter
in the MAINTENANCE section to
perform some of these operations.
We recommend that you have all
these operations carried out by a
Nanni authorized workshop.
NOTICE: It might be necessary to
adapt these operations depending
the climatic conditions. Contact
a Nanni authorized workshop for
further informations.
For prolonged storage (>12
months), a specific set of measures
must be performed. All these ope-
rations should be carried out by a
Nanni authorized workshop.
I CAUTION
If the engine is likely to be
subject to frost, drain all coolant
and water in the coolant and
seawater circuits. Indicate by
any means that there is no coo-
lant in the engine.
57

Long term storage

procedure
Complete the nearest periodic
maintenance inspections and ope-
rations before performing the long
term storage procedure.
1. Drain and change the engine
and transmission oil.
2. Change the engine oil filter.
3. Change the fuel filter and pre-
filter.
4. Run the engine to normal ope-
rating temperature.
5. Stop the engine and take the
boat out of water.
6. Drain, clean and inhibit all com-
ponents of the seawater system.
7. Remove the impeller from the
seawater pump (if fitted). Store it
in a cool and dry place. Indicate
by any means that the impeller
has been removed.
8. Check the engine coolant level
and condition. Top up if neces-
sary.
9. Drain any water and contami-
nants from the fuel tank.
10. Fill totally the fuel tank.
11. Remove the air filter. Secure all
air intake with clean clothes.
12. Clean the engine. Repair any
damaged areas of paintwork with
Nanni original paint.