Operation; Before Starting - Nanni N2.10 Notice Et Mode D'emploi

O
6
PERATION

Before starting

I WARNING
Put all the protective covers back
before starting the engine.
I CAUTION
Open the sea cock (if equipped)
before starting the engine. The
raw water pump impeller will be
damaged if it runs dry even for
few seconds, and may lead to
engine overheating.
Perform all of the following opera-
tions before starting the engine:
1. Open sea cock (if fitted). Prime
the raw water system if neces-
sary.
25
2. Start the compartment fan (if
fitted) for at least five minutes.
Otherwise, open the hold.
3. Check that there is sufficient
fuel.
4. Move the control lever to the
neutral position.
5. Open fuel cock, prime the sys-
tem if necessary.
6. Check the engine and trans-
mission oil level and fill with the
recommended oil if necessary.
7. Check the coolant level, top up
if necessary.
8. Check the control cables,
grease the connections if neces-
sary.
9. Check there are no fuel, oil,
coolant or water leaks.
10. Check the alternator belt.
11. Switch ON the main switches.