Nanni N2.10 Notice Et Mode D'emploi page 30

Panel with key
1. Move the control lever to the
neutral position.
2. Push the manual stop control (if
fitted).
3. Insert the key in the ON/STOP
starter switch.
4. Turn the key a quarter-turn to
the right. All the warning lamps
come on and the acoustic alarm
sounds. After a few seconds, only
the ENGINE OIL PRESSURE
and BATTERY CHARGE LAMPS
remain lit.
5. Press the START button
halfway to start preheating. Hold
the button for 5 to 15 seconds,
depending on ambient tempera-
ture to preheat the engine.
6. Press fully to start the engine.
Once the engine has started, re-
lease the button, all lamps go out.
7. If the engine is fit with water
cooled exhaust elbow, check
that water flows from the exhaust
outlet at the hull. If the water does
not flow, stop the engine and
check the raw water system.
27
Panel without key
1. Switch the key of the main pa-
nel to ignition (if equipped).
2. Move the control lever to the
neutral position.
3. Push the manual stop control (if
fitted).
4. Press the ON/STOP button. All
the warning lamps come on and
the acoustic alarm sounds. After
a few seconds, only the ENGINE
OIL PRESSURE and BATTERY
CHARGE LAMPS remain lit.
5. Press the START button
halfway to start preheating. Hold
the button for 5 to 15 seconds,
depending on ambient tempera-
ture to preheat the engine.
6. Press fully to start the engine.
Once the engine has started, re-
lease the button, all lamps go out.
7. If the engine is fit with water
cooled exhaust elbow, check that
raw water flows from the exhaust
outlet at the hull. If the water does
not flow, stop the engine and
check the raw water system.