Service Schedule - Nanni N2.10 Notice Et Mode D'emploi

Service schedule

NOTICE: An operation requiring service every day requires service after
100 hours or every year, and so on. Some components may not be part of
the engine ordered.
Operations marked with
* Operations to perform after 20 operating hours or 45 days after commis-
sioning.
BEFORE OPERATING THE ENGINE
Check the engine & transmission oil level. Top up if necessary *.
Check the coolant condition and coolant level. Top up if necessary *.
Check the raw water filter and clean as necessary *.
Drain water from the fuel prefilter *.
Check the condition of the battery *.
Check the warning lamps of the instrument panel *.
Control and adjust general water tightness *.
Check the stuffing box condition *.
EVERY 100 OPERATING HOURS / AT LEAST EVERY YEAR
Clean the air filter. Change if needed.
Change the fuel filter *.
Check the condition and the tension of the belts. Change if needed*.
Check the anodes. Change if needed*.
Check and tighten the electrical connections & cables, the clamps and
screws *.
Remove the sediment from the fuel tank and drain the fuel tank.
Check the control unit, the condition of the cables, grease the cables *.
33
should be done in a Nanni workshop.