Instructions For The Operator; Overview; Delivery State; Scope Of Delivery - Greifzug tirak XA 300 P Mode D'emploi

Operation and Installation Manual
– Only authorized maintenance personnel are permitted to
undertake the maintenance and repair work, see ' 15.1
Authorized maintenance personnel' on page 16.
– Only qualified personnel who have been trained on the sys-
tem are permitted to install and operate it in compliance with
the instructions given in this manual.
– Private users are obliged to obtain training in the installation,
operation and maintenance of the unit by Greifzug He-
bezeugbau GmbH.
– Never stand beneath suspended loads. Cordon off the dan-
gerous area whenever necessary.
– Never grasp the wire rope while the hoist is operating.
– Never reach into the hoist's inlet or outlet whilst the hoist is
operating. Risk of being pulled in and crushed.
– Self-locking nuts must never be reused and they must al-
ways be exchanged for new ones.
– If the load cannot be guided by on-site means then a low-
twist wire rope with a swivel hook or a rope swivel must be
used.
– Hearing protection must be worn in the vicinity of the hoist.
– Relieve the pressure in the hoses before disconnecting
compressed air hoses or opening compressed air connec-
tions.
– Metal brackets and the motor can be cooler than 0°C or
warmer than 55°C depending on the operating conditions.
Frostbite or burns are possible.
– Insufficient working pressure can impair the hoist's functions
and can cause the brake to lock. Excessively high working
pressure can cause danger due to overloads. The load limit-
ing device reacts more slowly. Observe the specified work-
ing pressure.
2.2

Instructions for the operator

– If more than one person is entrusted with the tasks men-
tioned above then the operator must appoint a supervisor
who is authorized to issue instructions.
– The operator is also responsible for preparing clear operat-
ing, maintenance, repair and other working instructions and
ensuring that the unit is operated correctly by instructing and
training the personnel in the correct and approved utilization
methods.
– The operator is responsible for the correct operation of the
system as well as for adhering to the maintenance periods
and the undertaking of the service work.
– The operator is committed to maintaining the logbook sup-
plied with the system.
– You must always abide by the national accident prevention
regulations. EU Directive 89/391/EEC applies within the
European Union (in Germany the Betriebssicherheits-
verordnung (BetrSichV)). You must always abide by your
country's national accident prevention regulations.
– Provide suitable protective equipment such as safety
gloves, hearing protection and fall protection. Protection
against extreme weather conditions (e.g. sun protection,
EN–4
protection against cold) are also part of the personal protec-
tive equipment.
– Always ensure that the workplace is adequately lit.
– A copy of this manual must be provided and be readily
available to authorized personnel at all times.
– As Greifzug Hebezeugbau GmbH does not know the appli-
cations that the hoist described here will be used for in the
future, the system operator is therefore committed to inform-
ing their personnel about any new safety instructions as well
as any supplementary maintenance work.
– The system operator is responsible for selecting the anchor-
ing method and suitable rigging options.
– The anchoring devices must comply with the details given in
this manual or the applicable Directives / Standards.
– The use of non-original parts, in particular the use of other
than the prescribed original tirak™ wire ropes, will invalidate
the warranty of the manufacturer as well as the CE ap-
proval.
– Adhere to the permitted temperature range, see table 1 on
page II.
3

Overview

3.1

Delivery state

The hoist is delivered completely assembled.
3.2

Scope of delivery


Hoist with control valve

tirak™ wire rope in accordance with the order specifications

Original Operation and Installation Manual

Logbook

Test certificate

CE Declaration of Conformity

Limit switch (end valve) for switching off the lifting and pull-
ing motions in accordance with the order specifications.
Optional scope of delivery:

Maintenance unit

Compressed air hoses

Deflection roller

Brush attachments for cleaning the ropes

Hand valve for controlling the hoist
The lengths of the compressed air hoses must be stipulated
when ordering. See also ' 6. Optional accessories' on page 8,
' 7. Options' on page 8 and 'Pneumatic connection' on page 10 as
well.
Rev. 08/2010