Ryobi RBC26SESB Manuel D'utilisation page 4

EN
ASSEMBLY
UNPACKING
This product requires assembly.
Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list
are included.
Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
ATTACHING THE FRONT HANDLE (Fig. 2a)
Remove the securing bolts and bracket from the front
handle.
Align the pin into upper shaft slot.
Install the front handle onto the upper shaft.
Note: The front handle should tilt slightly towards the
operator when correctly fitted.
Place the securing bolts through the front handle and
securely tighten them into the captive nuts on the
bracket.
Note: Do not attempt to remove the pin on the bracket,
this pin limits the upper position of the front handle.
ATTACHING THE BLADE GUARD AND GRASS DE-
FLECTOR
BLADE GUARD (Fig. 2b)
To attach the blade deflector to the mounting bracket,
align the screw holes on the blade deflector to the bolts
on the mounting bracket.
Using the combination wrench supplied, tighten
screws securely.
ATTACHING THE GRASS DEFLECTOR (Fig. 2b)
NOTE:
must be attached to the blade guard.
Attach the grass deflector to the blade guard and align
the 3 screws on the grass deflector to the screw holes
on the blade guard.
Using the combination wrench supplied, tighten all 3
screws securely.
INSTALLING THE ReelEasy TM LINE TRIMMER HEAD
(Fig. 2c)
Stop the engine and disconnect the spark plug wire.
Remove the bump head from the drive connector.
Open the ReelEasy TM
depressing the latches on each side.
NOTE: The contents of the line trimmer head are spring
INSTALLING LINE IN REEL EASY LINE TRIMMER HEAD
(Fig. 2c)
Line Trimmer Head by
loaded, so keep your other hand over the line trimmer
head cover while depressing the latches.
Remove the line trimmer head cover, bump knob, and
line spool and set aside.
Place the cutting head housing on the drive shaft.
Make sure the housing is fully seated.
Install the hex bolt to secure the line trimmer head to
the drive shaft.
Tighten by using the hex-shaped opening on the inside
of the bump knob.
NOTE: Only use the bump knob to tighten the bolt. The
use of other tools may allow over tightening of the bolt,
which could damage the line trimmer head.
Reinstall the bump head spring into the line trimmer
head and push down to seat.
Reinstall the line spool.
For the straight shaft attachment with the ReelEasyTM
cutting head the spool should be placed so "For straight
shaft" is visible on the line spool.
Replace the bump knob by inserting it into the centre
of the line spool.
Replace the line trimmer head cover, aligning latches
with openings in the line trimmer head.
Press cover and line trimmer head together until both
latches snap into openings securely.
Install line as described in the next section of this
manual.
Use a 2.4 mm diameter monofilament string.
Stop the engine and disconnect the spark plug wire.
Cut one piece of string approximately 6 m in length.
Rotate the knob on the string head until the line on
knob aligns with the arrows on the top of string head.
Insert one end of the string into the eyelet located on
the side of the string head and push until string comes
out through eyelet on the other side.
Continue to push string through the string head until
the middle section of the string is inside the string head
and string outside the string head is evenly divided on
each side.
Rotate the knob on the line trimmer head to wind the
line. If using a straight shaft attachment, rotate the knob
clockwise.
Wind the string until approximately 20 cm remains
protruding from the string head.
Replace the spark plug boot.