Maintenance By The Owner / Operator; Maintenance Tasks Performed By A Qualified Electrician; Work To Be Carried Out - Mennekes EverBOX Grip Manuel D'utilisation

9.1.1

Maintenance by the owner / operator

The following maintenance tasks may be performed by the
owner / operator at regular intervals (this work may also be
performed by electrical laypersons).
Checking residual current devices (FI/RCDs)
Residual current devices (FI/RCDs) can vary in terms of
appearance and operation.
The test is usually carried out by pressing a test button,
which triggers the residual current device.
1
Fig.: 23. Checking residual current devices (FI/RCDs)
f Connect the device to the power supply.
¨ Section 7.3
f Press the test button (T) (1).
The circuit breaker is tripped and the toggle (2) is switched
(clicking sound).
f Return the toggle (2) to its initial position.
f If any faults occur during the checking process, contact
a qualified electrician.
9.1.2 Maintenance tasks performed by a qualified elec-
trician
T
Risk of fatalities due to electric shock
Danger of severe or fatal injury when touching live compo­
nents.
f Disconnect the device from the power supply prior to
the maintenance work.
Disconnect the device from the power supply.
¨

9.1.3 Work to be carried out

f Check the device for defects.
f Properly rectify any defects or damage.
2
f We recommend the use of original spare parts from
MENNEKES for repairs.
f After the repair, check the device for proper function.
If re­commissioning the device is not likely due to defects,
and with regard to further safe use, the device must no
longer be put into service.
The tasks described below may only be carried
out by a qualified electrician.
DANGER
Section 7.4
EN
53