Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Fig. 1
Center Splice
On The Post
Mark The
Edge Of The
Splice On
Both Sides
Fig. 2
OTP & PROUD POST: FLAT ATR INSTALLATION
Step 1:
Cutting the Flat ATR Spacer
1. Measure distance between brackets and cut ATR spacer to
length. As shown in Fig. 1.
2. The spacer can be 1/4" [6.5mm] shorter than the distance
between brackets.
3. If one of the screw holes was cut off during the sizing of the
ATR spacer, use a 5/8" [16mm] drill bit to add another hole
1" [25mm] from the end of the ATR spacer.
4. Attach the ATR Spacer using the provided self-drilling
screws with a 5/16" [8mm] Nut Driver.
5. All screw holes must have a screw installed.
Note:
• Flat ATR uses a full length ATR Spacer.
• Flat ATR Spacer fits between the brackets.
• DO NOT REMOVE BACKING OF DOUBLE SIDED TAPE UNTIL
YOU ARE READY TO PERMANENTLY ATTACH THE ATR.
46
PURE VIEW: Al
HOME GLASS BALUSTER INSTALLATION
13
Fig. 3
Publicité
Table des Matières
