SUOMY SPEEDSTAR Mode D'emploi page 13

While riding the motorcycle the visor must never be left in the
EN
intermediate positions; it must always be locked in the locking
positions.
Removing the visor — Figure 13
Open the visor until it is completely open.
Slide the lever (Q) and Keep it in tension (Q)
Remove the visor from its mechanism by rotating and at the same
time by pulling it outwards.
Repeat the operation on the opposite side.
1
Q
2
Q
3
FIGURE 13
24
Assembly — Figure 14
To assure the proper operation of the rotation system of the visor,
before fitting the visor back on, verify that all the parts (seats
on helmet, visor surface in contact with the moving parts) are
perfectly clean.
Open the visor completely. Position the visor on the mechanism so
that the rotation seat is inserted in the rotation ring.
1) Slide the lever (Q)
2) Press slightly to stick the hooks on the visor into the slots on the
rotation mechanisms
Repeat the operation on the opposite side.
After fitting the mechanism verify that the visor is tightly fixed to
the helmet, that it rotates freely and that it locks correctly into the
locking positions.
If this doesn't happen and the rotation mechanism of the visor
doesn't work correctly, do not use the helmet and contact Suomy
authorized personnel only.
2
Q
1
FIGURE 14
Adjustment — Figure 15
If after replacing the part, or after long use of the helmet, you
experience infiltration from the closed visor, it may be necessary to
adjust the mechanisms of the visor.
Lift the visor until it is completely open.
Remove the visor, as specified in the previous paragraph.
Loosen the two screw (R - S) without removing them and without
disassembling the mechanism.
Shift horizontally the whole mechanism and tighten the screws.
Repeat the operations on the opposite side by shifting the
mechanism on the same direction of the previous one.
Once finished, check if the visor can be easily closed and if it
adheres to the gasket.
R R
S
S
FIGURE 15
VISOR MECHANISM
Replacement — Figure 16
Removing the mechanism
After removing the visor as indicated in the paragraphs above,
loosen and remove the screws (R - S); then remove the mechanism
from the shell.
Fitting the mechanism
The mechanisms are not interchangeable. Before proceeding it is
necessary to identify the correct assembly side;
Put the mechanism on the shell, insert the screws tightening them.
After fitting the parts verify that the mechanisms are positioned
correctly and tightly fixed to the shell. Then fit the visor and adjust
it as specified in the above paragraphs.
After fitting the mechanism verify that the visor is tightly fixed to
the helmet, that it rotates freely and that it locks correctly into the
locking positions.
If this doesn't happen and the rotation mechanism of the visor
doesn't work correctly, do not use the helmet and contact
authorized Suomy personnel only.
R
S
FIGURE 16
EN
25