Care And Maintenance; Cleaning; Transport, Packaging, Storage; Disposal - Sensopart FT 50 C S1 Série Instructions De Service Et De Montage

Mounting and
operating instructions
9

Care and maintenance

9.1

Cleaning

Should the front screen of the sensor become dirty, wipe it with a soft cloth and if necessary use a cleaning agent for
plastic surfaces.
CAUTION
Never use aggressive detergents.
9.2

Transport, packaging, storage

Check the delivery upon receipt to ensure that it is complete and that no damage occurred during transport. Should
the delivery be damaged, contact the carrier immediately. When returning the sensor, the packaging must always be
sufficient solid.
INFORMATION
If a defect is found, a complaint must be made immediately. Claims can only be made within the
valid time limit.
9.3

Disposal

Electronic components are subject to the regulations governing treatment of hazardous waste and may only be
disposed of by specialist companies.
10

Troubleshooting

Description of error
It is not possible to configure
the sensor via the operating
keys.
The sensor is no longer
accessible with the set
address.
In the event of any other malfunctions, please contact us or our representations.
FT 50 C...S1 Colour sensor - GB - 068-13821 - 10.10.2011-04
Possible cause
The electrical lock is active and PIN 8
is on high.
The key lock command was activated
via the RS485 interface.
SET
The key was not pressed for long
enough (< 3 s) and configuration mode
was not activated due to the time lock.
The sensor was set back to factory
status and the sensor address was set
back to 1.
Remedy
Disconnect PIN 8.
The key lock function must be cancelled
via the interface.
Press
SET
> 3 s
Reset the address to the required value.
59