7.3.7 Menu „F": Configurating Special Functions - Sensopart FT 50 C S1 Série Instructions De Service Et De Montage

7.3.7 Menu „F": Configurating special functions
Individual functions are configurated or activated / deactivated in this menu.
Step Menu item Activity
1 Press
SET
> 3 s
until LED „C"
(yellow) flashes
2 Press
3 Special Press
functions
Reset to
factory
setting
4 Press
Drop-out
delay time
5 Press
Set signal
type „Q"
6 Press
Configure
PIN 8 input
46
Picture follows Remark
C S +/F
C S
+/F
4x
C S +/F
SET
C S +/F
C S +/F
C S +/F
C S +/F
LED „C" (yellow) flashes, when time lock is open and
configuration mode is activated.
Menu „Special functions" is selected.
LED „F" (green) flashes.
Menu „Special functions" is activated.
Sensor jumps to first setting (reset to factory setting)
LEDs „Tol. I" (red) flash.
LEDs „Tol. I" (red)
C S
flash.
Reset sensor to
factory setting with
SET
.
Continue to next function (drop-out delay time).
Drop-out delay
C S
time inactive:
Activate with .
SET
Continue to next function (Set signal type for switching
output „Q").
„Q" (PIN 3) is set
C S
as N.O.
Switch to N.C. with
SET
.
Continue to next function (Configure PIN 8 input).
PIN 8: Triggering is
C S
active.
Switch to key lock
function with .
SET
FT 50 C...S1 Colour sensor - GB - 068-13821 - 10.10.2011-04
Mounting and
operating instructions
SET
If was
+/F
pressed, the LED
„S+/F" (green)
flashes alternately
with LEDs „Tol. I"
(red) to confirm.
Drop-out delay
+/F
time active:
Deactivate with
.
SET
„Q" (PIN 3) is set
+/F
as N.C.
Switch to N.O. with
SET
.
PIN 8: lock is
+/F
active.
Switch to triggering
function with
SET
.