Use And Configuration; Displays And Configuration Elements - Sensopart FT 50 C S1 Série Instructions De Service Et De Montage

Mounting and
operating instructions
7

Use and configuration

The sensor has different operating modes and functions. It has a serial RS485 interface for the transfer of colour
values and configuration of sensor functions.
Sensor configuration can be carried out via the control panel using the
CAUTION
Push bottons only with finger! Do not use sharp objects!
7.1

Displays and configuration elements

Keys and their functions:
Keys Description
SET
SET
Continue
Entire control
SET
panel
ESC
INFORMATION
A time lock prevents short unintentional pressure on the
mode.
Once configuration mode has been opened, a time window (duration approx. 20 s) also opens.
Should no further input occur during this period, then the sensor switches back to operating
mode.
The LEDs (illustr. 12) indicate the selected menus and configurations.
LED Colour Use
Green Operating mode
display
C Yellow C = Colour
 teach colour
 Signal status
FT 50 C...S1 Colour sensor - GB - 068-13821 - 10.10.2011-04
In operating mode
Pressing key > 3 s activates configuration
mode
 LED „C" flashes yellow to confirm
No function
No function
Conf.
C S +/F
SET
Tol.C
ESC
Tol.I
In operating mode
LIGHTS UP,
when sensor is ready for use.
LIGHTS UP, (in switching
mode N.O. = Factory setting)
if object colour = taught colour
(switching output „Q" = active).
Function inverted when swit-
ching mode N.C. is selected.
SET and keys.
General operating functions
In configuration mode
Quick press and release:
 jump to next menu
 save and confirm set values
Alter configuration and jump to next
menu / point
Pressing both keys together activates ESC
(Escape)
 quit configuration mode without saving
modifications
key from activating configuration
SET
Illustr. 12
15500349
Display function
In configuration mode
LIGHTS UP,
when sensor is ready for use.
FLASHES,
if menu „C" (teach a colour) is
selected,
FLASHES with „+/F",
if menu „C+" is selected.
39