Menu „C+": Teach, Add, Link Further Colours - Sensopart FT 50 C S1 Série Instructions De Service Et De Montage

Mounting and
operating instructions
Teach-in colours via input IN ET:
The teach-in procedure can also be initiated by means of the input cable IN ET (PIN 6). For this purpose, the input
cable must be set for > 3 s to High (time lock).The colour is taught by the variation of the edge (from High to Low).
After the teach-in process, the colour is stored with the last manual tolerance settings. If a colour has not yet been
taught manually (via the control panel), the factory values (colour value tolerance level 3 / intensity tolerance level 2)
are adopted.
7.3.4 Menu „C+": teach, add, link further colours
INFORMATION
• The „C+" (Teach +) function enables the teaching of 1 to 4 further reference colours. They are
automatically linked to one another. Previously taught and scanned colours / colour ranges
remain stored.
• Colour and intensity tolerance are set individually during the programming process.
• If more than 5 colours are taught, the oldest is erased (FIFO).
• After the teach-in process, the yellow LED „C" lights up when the switching output „Q" is
active a colour has been detected (when switching mode = N.O. = Factory setting is selected).
Procedure:
Step Menu item Activity
1 Operating Position object
mode (no
menu item)
2 Press
SET
> 3 s
until LED „C"
(yellow) flashes
3 Press
4 Teach Press
colours
5 Release
6 Press
several
times until
the required
tolerance is
selected
FT 50 C...S1 Colour sensor - GB - 068-13821 - 10.10.2011-04
Picture follows Remark
C S +/F
C S +/F
SET
C S +/F
SET
Observe operating parameters such as scanning distance,
direction of movement, inclination etc. (see chapter 5
„Mounting").
LED „C" (yellow) flashes, when time lock is open and
configuration mode is activated.
Menu „Scan further colours" is selected LED „C" and „+"
(yellow) flashes.
Press button briefly and release it. When the button gets
released, the colour is taught.
Colour value is stored in sensor.
Sensor is ready for the setting of colour tolerance.LED „C"
(yellow) lights up when colour is detected,*
LEDs „Tol. C" (green) light up.
Select colour tolerance (colour selectivity)
1 2
C S +/F C S +/F
1 = smallest tolerance, 4 = greatest tolerance
2 = factory setting
3 4
C S +/F C S +/F
43