Menu „S+": Scan, Add, Link Further Colour Ranges - Sensopart FT 50 C S1 Série Instructions De Service Et De Montage

Mounting and
operating instructions
Step Menu item Activity
5 Release
Scanning a colour via input IN ES:
The scanning process can be activated via the input cable IN ES (PIN 4). For this purpose, the input cable must be
set for > 3 s to High (time lock). Then the colour is scanned for as long as the signal at PIN 4 is high.
7.3.6 Menu „S+": Scan, add, link further colour ranges
INFORMATION
• The „S+" („Scan +") function makes it possible to scan 1 to 4 further colour ranges and extend
the colour range by up to 4 steps.
• When a colour range is scanned with „S+" (Scan+), previously taught and scanned colours
remain stored.
• If more than 5 colour ranges are taught, the oldest is erased (FIFO).
• After the scanning process, the yellow LED „C" lights up when the switching output „Q" is
active a colour has been detected (when switching mode = N.O. = Factory setting is selected).
Procedure:
Step Menu item Activity
1 Operating Position object
mode (no
menu item)
2 Press
SET
> 3 s
until LED „C"
(yellow) flashes
3 Press
4 Scan further Press
colour
range
and keep
pressed
5 Release
Repeat steps 1-5 of the configuration process to teach (add) further colour ranges.
FT 50 C...S1 Colour sensor - GB - 068-13821 - 10.10.2011-04
Picture follows Remark
C S +/F
SET
Picture follows Remark
C S
+/F
C S +/F
3x
SET
C S +/F
SET
Colour range is stored.
Sensor is ready for use.
LED „C" (yellow) lights up, when colour is detected / swit-
ching output „Q" is active (when switching mode = N.O. =
Factory setting is selected).
Observe operating parameters such as scanning distance,
direction of movement, inclination etc. (see chapter 5
„Mounting").
LED „C" (yellow) flashes, when time lock is open and
configuration mode is activated.
Menu „Scan further colour ranges" is selected LED „S"
and „+" (yellow) flashes.
The colour range is scanned for as long as
pressed.
Additional colour / colour range is stored.
Sensor is ready for use.
LED „C" (yellow) lights up, when colour is detected / swit-
ching output „Q" is active (when switching mode = N.O. =
Factory setting is selected).
SET
is
45