Operation And Setting; Displays And Configuration Elements - Sensopart FT 50 RLA-70-PL5 Instructions De Service Et De Montage

7

Operation and Setting

The FT50RLA is ready to operate after applying the operating voltage.
However, the following settings can be made if necessary.
Sensor configuration can be carried out via the control panel using the
CAUTION
Push buttons only with finger! Do not use sharp objects!
7.1

Displays and configuration elements

Keys and their functions:
Keys Description
Entire control
panel
SET
Continue
The LEDs (illustr. 2) indicate the selected settings.
BA ZA
LED Colour
BA
ZA
Q QA
A OK
V
Q
N FS
C
QA
Av
OK
Nc
FS
Illustr. 8
06013487
18
In operating mode
Simultaneous pushing (> 3 s)
activates the setting mode
No function
No function
Use
Green Operating indicator
Red Status indicator
(only active in the Set mode)
Yellow Indicates status of output Q
Yellow Indicates status of output QA
Green Signals operating mode
(speed/averaging)
Green Stability indicator (good target) Lights: object safely detected and in the
Green Signals switching type N.O./
N.C.for output Q
Green Factory Setting
(only active in Set mode)
and
General operating functions
In configuration mode
Push the button first and then also the
button.
Then all settings are saved.
After releasing the
run mode.
Pushing the button briefly changes the respective
function or results in adoption and confirmation of
the set values.
Change settings and select next function.
Description
On: ready for operation (Run mode)
Flashing: Set mode is active
Lights: selected setting is active
Lights: switching output active
Lights: object is within the set 0% and
100 % range
Lights: operation set with averaging
operating range
Lights: switching type N.C. set
Lights: factory setting selected
FT 50 RLA Distance sensor - GB - 068-13799 - 27.07.2010-01
Mounting and
operating instructions
keys.
button, the sensor is in