Deactivating The Set Mode (Exit) - Sensopart FT 50 RLA-70-PL5 Instructions De Service Et De Montage

No. LED pattern Action
Description
2 Scaling of the analogue output QA
Q QA
A OK
Position the object at the desired 0 % point (4 mA). The „OK" LED must light.
V
N FS
Push
C
Push
tance is saved as the 0 % point (4 mA). The „ZA" LED (red) flashes with 1 Hz.
If no 100 % point is to be set, exit the Set menu (
setting with
If a 100 % point is to be set, place the object at the desired distance.
The „OK" LED must light.
Push
distance is saved as the 100 % point (20 mA). The „ZA" LED lights for confir-
mation for as long as
Exit the Set menu (
go to the next setting with
Information
If the distance between the 0 % point is less than 5 % of the operating range, the analogue output is
automatically scaled to 5 % of the max. operating range. The middle of the range is placed between the
set 0 % and 100 % points.
3 Switch operating mode (speed mode / averaging mode)
Q QA
A OK
Push
V
N FS
The operating mode (speed / averaging) is changed by pushing
C
repeatedly.
Look at the „ZA" LED (red). „ZA" lights
Exit the Set menu (
go to the next setting with
Information
Averaging Mode: for detecting rough surfaces. The arithmetic (floating) average of 100 measured values
is taken. This smoothes the measuring result.
Speed Mode: for shortest response time and max. switching frequency without averaging.
4 N.O. / N.C. switching
Q QA
OK
A
Push
V
N FS
The switching function (N.O. / N.C) is changed by pushing
C
Look at the „ZA" LED (red): „ZA" lights
Exit the Set menu (
go to the next setting with
5 Activate Factory Setting
Q QA
OK
A
Push
V
N FS
Push
C
The sensor is reset to the factory state.
The „ZA" LED lights for confirmation for as long as
Exit the Set mode (
go to the next setting with
7.4.3

Deactivating the Set Mode (Exit)

First push , then . All settings are then saved. The sensor is in the Run mode after releasing the buttons. The
operating indicator „BA" (green) lights steadily.
20
until the „QA" LED lights.
once. If the object is detectable and in the operating range, the dis-
.
once. If the object is detectable and in the operating range, the
is pushed.
+ ) or
.
until the „Av" LED lights up.
„ZA" does not light = speed mode is active.
+ ) or
.
until the „Nc" LED lights.
„ZA" does not light = switching type N.O. is active.
+ ) or
.
until the „FS" LED lights.
once.
+ ) or
.
operating instructions
+ ) or go to the next
= averaging mode is active.
repeatedly.
= switching type N.C. is active.
is pushed.
FT 50 RLA Distance sensor - GB - 068-13799 - 27.07.2010-01
Mounting and
Factory setting
Maximum
operating range
speed mode
N.O.