Water Drainage - EUROM Coolsmart 90 Manuel D'utilisation

Reset button
As soon is reset is pressed, all settings are disabled. The remote control returns to
the factory settings.

Water drainage

1. During dehumidifying
During dehumidifying, additional water
is extracted from the air. Therefore,
remove the drain plug, connect a drain
hose to the water drain connection (7)
during the dehumidifying process and
route this hose to a lower positioned
water drain.
Make sure that the hose is attached
firmly and does not leak. Direct the
hose to the drain and make sure that it
does not bend, which would stop the
flow of water.
Once you finish using the hose, then
put the drain plug and knob back to
prevent leakage.
2. During the COOL process
During this process, water is extracted from
the air. This largely evaporates, but any
excess water accumulates at the bottom
water reservoir. When the water reservoir is
full, the air conditioner will beep 8 times and
the display will show P1. The motor and the
compressor will stop working, but not the fan.
Switch off the air conditioner and remove the
plug from the socket.
Move the air conditioner to a drain location
and empty the water reservoir by removing
the drain plug and connecting a hose. Make
sure that as soon as the water reservoir is
empty, the drain plug is securely re-inserted
to prevent leakage. The symbol P1
disappears. If the error recurs, contact your
supplier.
83