Water Outlet - EUROM PAC 120 Manual D'instructions

 Using the <Up> and <Down> buttons, set the number of hours after which the
air conditioner has to stop (1-24 hours).
 Press the <Timer> button once again. The display of the air conditioner shows
the set number of hours.
The air conditioner will automatically stop after the lapsing of the set number of
hours.
LED display
The display shows the configured temperature or the timer settings. The display also
shows the error codes, see further on in this manual.
Additional comments
 When you start the PAC 120 / PAC 140 and opt for a specific function or change
function, the ventilator will work but the compressor will not start immediately:
the latter to protect the internal components. The symbol that belongs to the
configured function blinks on the display, a sign of the 'waiting mode'. This can last
3 to 4 minutes.
 In case of prolonged strong cooling, ice accretion can occur on the interior of the
PAC 120 / PAC 140. You notice this because the device performs less. To solve this
you switch off the device and give it time to defrost.
 When the required cooling or heating temperature has been attained, the PAC 120
/ PAC 140 will continue ventilating but the compressor discontinues operating.

Water outlet

During cooling and dehumidification, the device extracts water from the air. This
largely evaporates again,
but possibly. excess water
accumulates in the water
reservoirs. When full, the
compressor and motor
stop automatically and the
"water tank full" (W.F)
light turns on. In that
case, switch off the air
conditioning and remove
the plug from the socket.
You empty the water
reservoirs by removing
both sealing caps from the
top and bottom water
drainage point (see
pictures) and draining the
reservoirs into a drain or
collecting them in a
container or similar. Do not
46