Water Outlet - EUROM 7000 Manuel D'utilisation

- The room temperature becomes lower than the set temperature.
- The timer is set to a final time.
 If you wish to ventilate, use the function selector button to choose 'fan'; you
can then set fan speed to high or low using the fan speed button.
 The Timer button allows you to automatically start or stop the air conditioner
at a set time.
Automatic starting: the air conditioner is off. Press the timer button and choose
the moment that you would like it to start working using the temperature
buttons: each time you press 'temperature up' the hour will increase, each time
you press 'temperature down', the hour will decrease. If, for example, the
display shows 5 hours, the air conditioner will switch on in 5 hours.
Automatic stopping: the air conditioner is on. Press the timer button and choose
the moment that you would like it to stop working using the temperature
buttons: each time you press 'temperature up' the hour will increase, each time
you press 'temperature down', the hour will decrease. If, for example, the
display shows 2 hours, the air conditioner will switch off in 2 hours. The timer
can be set to between 1 to 24 hours.

Water outlet

During the cooling process, the device removes water from the air. This largely
evaporates but any excess water is collected in the water reservoir. If the water
reservoir in the device is full, the compressor and
the motor will stop automatically and the 'water
tank full' light (FULL) will come on. In this event,
switch the air conditioning unit off and remove the
plug from the socket. Empty the water tank by
removing the cap from the water drainage point
(see picture) and draining the tank into a drain or
receptacle. Do not forget to replace the cap again
afterwards! You can then switch the air
conditioning unit back on.
When dehumidifying, more water is removed from the air. This is why you must
connect a hose to the water drainage hose during dehumidifying and run this to a
drain (at a lower point).
Safety
The Eurom 7000 and Eurom 9000 are fitted with an overheating safeguard that
switches the unit off if it overheats. If this should occur, you must remove the plug
from the socket and leave the equipment to cool for at least 30 minutes. Remove
the cause of overheating - has the device been (partially) covered? Is it too close to
a wall or another obstacle, preventing it sucking in or dispelling sufficient air?
You can then use the device normally again but keep an eye on it for the first 30
minutes to ensure there are no further problems. If the device is showing signs of
22