EUROM 7000 Manuel D'utilisation page 17

5. If the appliance is not being used, or if you are cleaning, servicing
or moving it, switch it off first and then unplug the appliance.
Always move and / or move the device quietly!
6. Even when you start using the appliance: firstly plug in the mains,
then the switch to the ON position and only then use the control
button!
7. Do not use the device in a damp or wet environment, near a bath,
shower or swimming pool and do not splash water, oil or any liquid
on or in the appliance.
8. Avoid using extension cords as much as possible. If this is
unavoidable, use a cord with sufficient capacity (at least 3 x 1.5
mm²) and keep it outside the walking route!
9. Do not move the appliance by pulling on the electrical cable and
take the plug in your hand if you want to take it out of the socket.
10. Do not pull on, deform or modify the electrical cable or immerse it
in water. Pulling or misuse of the electrical cable will cause damage
to the device and cause an electric shock
11. If the electrical cable, plug or the appliance itself is damaged,
broken, or malfunctions, do not use it or switch it off immediately
and remove the plug from the socket. Device, plug and / or cable
must be repaired/replaced by an electrician or similarly qualified
person. Repairs by inexperienced people will invalidate the warranty
and can cause dangerous situations!
Safety in relation to coolant R290
1. This device contains the coolant R290. R290 is a coolant that
complies with the relevant European Directives. Never perforate the
coolant circuit. R290 is flammable (GWP 3)!
2. Never use substances other than those recommended by the
manufacturer for the defrosting process.
3. This device must be used and stored in a room that does not
contain sources of ignition, such as open flames or gas and
electrical devices in operation.
4. Do not perforate any of the components of the cooling circuit and
do not set light to the device
5. If the device is installed, working or stored in an un-ventilated you
must take measures to prevent fire or explosions caused by leaked
coolant. Ensure that there are absolutely no sources of ignition
(such as fire, heaters, sparking electrical equipment, lit cigarettes,
etc.) in the same room!
17