EUROM 7000 Manuel D'utilisation page 21

The operational panel and the remote control have the same buttons
1. ON/OFF button (Power)
2. Temperature up button
3. Temperature down button
4. Receiver remote control (only on operational panel)
5. Function selector button
6. Fan speed button
7. Timer button
8. Battery capacity (AAA-1,5V 2x) (only in remote control)
FULL – 'Tank full' light, see page 22 (only on operational panel)
The operational panel also has 7 indicator lights that show which settings are active
and a display (Led display) that shows any values set.
Before using the air conditioner, check:
 That it has been installed according to safety instructions
 That it is not damaged or broken
 That the electrical socket that you wish to use has the same voltage as is given
on the unit's specification plate (220-240V / 50Hz)
 That no other devices are connected to the same socket
 If this has all been checked, you can insert the plug into the socket. Start the
unit by pressing on the ON/OFF button.
 Use the Function selector button to choose a specific function: cool,
dehumidify or fan. Every time you press the button, the function changes. The
lights show which function is active. If you are cooling or dehumidifying, wait for
up to 3 minutes after switching on or off before switching the unit on or off
again. The compressor needs this time to recover.
 Use the Fan speed button to set the fan to high or low.
 If you wish to cool, you can use increase or decrease the temperature using the
Temperature up/down buttons. Every time you press these buttons, the set
temperature will increase or decrease by one degree. The display shows the
value set. The temperature can be set to between 16 and 31°C.
 If you wish to dehumidify, press the function selector button until the 'dehum'
light comes on. Check that the water outlet hose is correctly connected, see
page 22! The temperature will be automatically set to 2 degrees below room
temperature (16°C to 31°C).
The fan speed will be automatically set to 'LOW'.
Caution: Because the temperature in the dehumidifier setting is set
automatically to 2 degrees below room temperature, the device will cool down
the room.
 Using the functions 'cooling' and 'dehumidifying', the apparatus will occasionally
stop in order to protect the compressor. The apparatus will restart after approx.
3 minutes. Do NOT change any settings in the meantime!
If you set the apparatus to 'cooling' or 'dehumidifying', it will continuously
operate unless:
21