EUROM 7000 Manuel D'utilisation page 19

1. rear panel
2. air inlet
3. front panel
4. operating panel (top)
5. air inlet
Accessories
A. Outlet hose hot air
B. Connector window panel
C. Connector air conditioner
D. Window panel
Installation
The Eurom 7000 and 9000 are mobile air conditioning/ dehumidifying units that can
be moved from room to room. Install as follows:
 Remove all packaging material, keep it away from children and ensure that the
unit remains in an upright position.
 Before use, check that all accessories are present and that there is no damage to
the accessories or the unit itself. Do not use a damaged unit; take it back to
your supplier!
 Place the unit on a sturdy, flat, dry and horizontal base near an electrical socket
and a discharge point for hot air, e.g. a window that can be opened slightly.
Make sure that the unit has at least 30 cm of free space on all sides and take all
safety instructions into account.
Dehumidification
 To use the dehumidification function, connect the water drainage hose to the
water drainage point (9). This hose should lead to a bucket or drain. The hose
should not run upwards! Your unit is now ready for use.
Caution: When using dehumidifier mode, the air drainage hose also needs to be
placed outside. The moisture the device extracts from the air inside the room is
pulled outside through the air drain hose. The remaining moisture is only drained
using the drainage valve if not all of the moisture can be led outside through the
drainage hose.
6. electrical cable with plug
7. wheels
8. waste pipe connection hot air
9. water drainage point
19