EUROM Coolsmart 90 Manuel D'utilisation page 74

3. Mode
Select the desired function. Every time you press the button, the function
changes in the following sequence: AUTO-COOL-DRY-FAN. The lamp on the
control panel shows which function is activated.
4. Fan
Using this button, the following fan speeds can be selected: LOW-MID-HIGH-
AUTO. The lamp on the control panel shows which speed is activated.
5. Timer
The timer button is used to automatically switch the air conditioner to ON/OFF by
means of a time programme, combined with pressing the < > buttons.
The lamp on the control panel shows whether Timer On or Timer Off is activated.
6. Sleep (Eco)
Using this button, you start the Sleep (Eco) function.
Filter
Remark: After 250 operating hours, the filter indication lamp automatically lights
up. This function is a reminder to clean the air filters. Press 3 seconds on the
Sleep button to reset.
7. Swing
Using the Swing button, you automatically move the horizontal outlet slats up
and down when the air conditioner is activated.
8. Wireless
This button is used to initiate a WiFi connection. Press 3 seconds on the Wireless
button to create a connection. The display will show 'AP'. If within 8 minutes
contact is made with the router, then the lamp on the control panel turns on. To
switch off the WiFi connection, press on the Wireless button and the < button.
Remark: When you want to restart the WiFi connection, it might take some time
before it connects with the network.
Operation
Cooling:
Press the Mode button on the control panel until the lamp Cool turns on.
-
Press on the < > buttons to set the desired room temperature from 17 to 30°C
-
Press the Fan button to switch on the desired fan speed.
-
The hose for the warm air discharge must be connected.
-
The condensate discharge hose does not need to be connected.
-
Drying
Press the Mode button on the control panel until the lamp Dry turns on.
-
The temperature and fan speed cannot be adjusted.
-
The hose for the warm air discharge does not need to be connected.
-
The condensate discharge hose needs to be connected; see the section about
-
water discharge.
Auto
Press on the Mode button until the light Auto comes on.
-
The air conditioner will automatically cool or fan depending on the set
-
temperature and the room temperature.
74