EUROM Coolsmart 90 Manuel D'utilisation page 80

Timer operation
Press the Timer ON button to set the automatic
switch ON time; press the Timer OFF button to set
the automatic switch OFF time.
1. Setting the time for automatic switch ON.
a. Press the TIMER ON button. The remote
control shows TIMER ON, the signal 'h' is
shown on the LCD display. The air
conditioner is now ready for setting the
switch-on time.
b. Press again on the TIMER ON button to set
the desired switch-on time. Every time you
press the button, the time increases in
steps of 30 minutes until 10 hours and
henceforth in steps of 1 hour to 24 hours.
c. After the switch-on time is set, it takes half
a second before the remote control
transmits the signal to the air-conditioner.
After approximately 2 seconds, the 'h'
signal disappears and the set temperature
appears again on the LCD display.
The timer function control light on the air conditioner goes on.
2. Setting the time for automatic switch OFF.
a. Press the TIMER OFF button. The remote control shows TIMER OF, the signal
'h' is shown on the LCD display. The air conditioner is now ready for setting the
switch-off time.
b. Press again on the TIMER OFF button to set the desired switch-off time. Every
time you press the button, the time increases in steps of 30 minutes until 10
hours and henceforth in steps of 1 hour to 24 hours.
c. After the switch-off time is set, it takes half a second before the remote
control transmits the signal to the air-conditioner. After approximately 2
seconds, the 'h' signal disappears and the set temperature appears again on
the LCD display. The timer function control light on the air conditioner goes
on.
Important: Important: setting the time in the Timer: 0.5, 1, 1.5, 2, 2.5, 3, 3.5, 4,
4.5, 5, 5.5, 6, 6.5, 7, 7.5, 8, 8.5, 9, 9.5, 10, 11, 12, 13, 14, 15, 16, 17, 18, 19, 20,
21, 22, 23 and 24.
80