Electrical Connections - EURAPO ESTSV Série Manuel D'utilisation Et Installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6.6 ELECTRICAL CONNECTIONS

Before making any electrical connection, verify the compatibility between power supply
and the technical features of the fancoil and/or of the other accessories to be connected
to the unit. These features are illustrated in the identification plate, located on one side of
the fancoil (Fig. 1).
In the power supply system to the fancoil, a double-pole switch must be fore-
seen with a minimum distance of 3 mm between contacts in each poles.
For a correct management and use of the EST fancoil, the use of an EURAPO microproces-
sor control or OMNIBUS control is suggested. The control has to be chosen according to
the requirements of the installation.
Each EST fancoil is provided with:
screw terminal board for the electrical connections, located inside the electric box
ESTCBL00 (s. Enclosure 4 - Fig. 1);
specific electric wiring diagram for the ordered unit with its relevant accessories;
ground protection terminal marked with the symbol
ground protection system cable (yellow/green).
For connecting the EST fancoil unit to the electric system, operate as follows:
1. Insert the wires (factory pre-wired cable) through the
slots of the control box (s. Enclosure 1/A, 1/B or 1/C, point
5) and make the electrical connections accordingly to the
electric wiring diagram located in the front inner part of
the unit and to the diagram of the controller.
2. Fix the wires to the base of the control panel by using
the given clamps and be sure that the wires under the
panel with the slots are blocked at a distance of at least 5
millimeters from the slots themselves.
3. Fix back the cover box to the base with the screw.
4. Pay attention to the fixing and the path of the connec-
tion cables, as illustrated in Fig. 7.
5. Make sure that the installation doesn't damage the
components and cannot be of any danger to persons,
objects or animals.
ALWAYS GROUND THE UNIT.
or the connection of the
Fig. 7
EN
1
2
3
4
5
6
7
8
9
10
+
31

Publicité

Table des Matières
loading

Table des Matières