Assembling The Bus Coupler; Adressing; Manually Addressing; Baud Rates - Aventics CANopen LP04 Mode D'emploi

32 AVENTICS | CANopen | R402001988–BDL–001–AC

Assembling the bus coupler

6 Assembling the bus coupler
6.1

Adressing

The units and tens digits for the module ID are switched by the
rotary switches (refer to Fig. 1). IDs from 0 to 99 are allowed.
O
Unscrew the caps of the rotary switches, tens and units.
O
Address the rotary switches by turning with a screwdriver.
– See table 4 for LED functions.
6.1.1

Manually addressing

The following addressing rules to manually address a
participant in a CANopen line apply:
W
Double assignment of CANopen addresses is not permitted.
W
The order of the participants in the CANopen line is
independent of the addressing order.
W
The address "0" is not permitted.
The CANopen address rotary switch is labeled according to a
decimal system.
6.2

Baud rates

The Baud rates are switched by the DIP switch (refer to Fig. 1).
W
The switches are marked from 1 to 6.
W
The switches 1 and 6 have no function
O
Remove the protective cap.
O
Put the switch in open position by pushing it in the direction
away from the valves.
O
Put the switch in closed position by pushing it in the
direction towards the valves.