Notes On Safety - Aventics CANopen LP04 Mode D'emploi

AVENTICS | CANopen | R402001988–BDL–001–AC
2.4

Notes on safety

W
Observe the notes on safety and familiarize yourself with the
contents of the operating instructions before installing the
devices and connecting them to a compressed air supply or
the power supply.
W
Do not change or modify the device unless it is described in
the operating instructions. Changes may only be performed
by a qualified technician.
W
Only use the device within the performance range provided
listed in the technical data. If the limit values listed in the
technical data are not observed or are exceeded, the devices
may overheat or be completely destroyed, the functions
and/or electrical safety may be impaired.
W
To comply with the technical data, only use the cable
suppliers that are listed in the operating instructions on
Table 6 or, in the project drawings.
W
Ground the devices according to the instructions. Please
observe the relevant DIN/VDE standards or country-specific
regulations when installing the system/device.
Especially observe:
– VDE 0160 (DIN EN 50178)
– VDE 0100
W
The power supply must be isolated according to
DIN EN 60742, classification VDE 0551. Please observe any
specifications on external fuse protection.
W
Appropriate transport, and correct storage, setup and
installation are required for the devices to work safely and
without failure.
W
Installation and initial start-up may only be performed in a
voltage- and pressure-free state and by a qualified
technician. Please comply with the installation position in
the operating instructions.
W
In order to avoid accidents, electrical start-up is to be
carried out only in a pressure-free state.
W
Only start the devices after they are completely assembled
as well as correctly wired, and tested.
25
For your safety