Clean The Stainless Steel; Inspect The Parts - Arneg Venezia 2 TCBM Manuel D'installation Et De Service

Venezia 2 TCBM-TCPW
English
Aluminium • Use a soft cloth with a neutral de-
tergent or soap and lukewarm wa-
ter (max 30°C)
• Immediately remove all traces of
water or detergent using a dry
cloth in order to prevent marks
from forming.
Wood • Use a soft cloth with a neutral de-
tergent or soap and lukewarm wa-
ter (max 30°C)
• Immediately remove all traces of
water or detergent using a dry
cloth in order to prevent marks
from forming.
• If necessary, before treating the en-
tire surface, test on a small hidden
area and verify that the cleaner will
not damage the finish or colour

21.6 Clean the stainless steel

Certain situations can cause the formation of rust on the surfaces in steel, such as:
remains of iron left on damp surfaces, limescale, unrinsed chlorine-based or ammonia-based deter-
gents, encrustations or food residue, salt-salt solutions, dry residue of evaporated liquids
Remedy recent stains and rust:
clean with shampoo or neutral detergents, using a sponge or a rag.
When finished, eliminate any detergent residue, rinse and thoroughly dry the surfaces.
old stains and rust:
use chemical substances on the stainless steel that contain 25% of nitric acid or similar
substances.
persistent stains and rust:
sand with a stainless steel brush, wash with detergent and dry thoroughly.
CAUTION! Slippery floor. Falling.
Remove from the floor any items such as sponges, rags, waste of water or detergent.
Carefully clean any residue of detergent or sanitizer.
i
Carefully follow the sanitizing, rinsing and drying procedures to prevent proliferation of
harmful bacteria.

21.7 Inspect the parts

Once you have completed sanitizing, rinsing and drying, proceed as follows:
Step
1 check that all parts are perfectly clean and dry
2 check that they are not damaged or too worn
3 replace worn parts with new ones provided by the manufacturer
4 install the parts perfectly dry
5 restore electrical power supply
Once the internal operating temperature has been reached, it is possible to load the products.
42
This intervention may however cause scratches to the surfaces due to the abra-
sive cleaning method. DO NOT use hydrochloric acid on stainless steel surfaces
DO NOT use acid or alkaline detergents (e.g.
bleach) which could corrode the surfaces
DO NOT use rough or abrasive materials or
metal scrapers that scratch the aluminium
surfaces
DO NOT use steam cleaning equipment
DO NOT use dirty cloths
DO NOT use spray cans, acid or alkaline de-
tergents (e.g. bleach), soda or solvents which
could corrode the surfaces
DO NOT use rough or abrasive materials that
could scratch the surfaces
DO NOT use steam cleaning equipment
DO NOT use rough cloths
moderate the use of liquid detergent: overuse
causes seepage and then swelling of the wood
Action
05060208 00 03-2021