Clean Specific Materials - Arneg Venezia 2 TCBM Manuel D'installation Et De Service

To clean the bain-marie model (TCBM), completely drain the water, see chap. 16.4.
After cleaning, refit the overflow pipe Fig. 16 -A-

21.5 Clean specific materials

Material
• use a soft cloth with a neutral de-
tergent or soap and lukewarm wa-
ter (max 30°C)
• Immediately remove all traces of
water and detergent with a dry
Glass
cloth in order to prevent marks
from forming and to prevent liquid
from reaching the gaskets, frame,
or the glass door hinges.
Step
1
Procedure
2
for disas-
3
sembly of
4
the sliding
closure
5
devices
6
7
1
• use a cloth soaked in neutral deter-
Plastic
gent
(door seal
• clean with a cloth soaked in clean
profiles)
water
05060208 00 03-2021
Remedy
slide the glass lids towards the centre
move the lids upwards to make them come out from the lower rail guides
rotate the lower part towards the operator
remove the lids
gently place them on a flat surface protected by a soft cloth, DO NOT break or
damage them
clean as indicated in the glass parts cleaning section (chap. 23.5)
Reinstall the closing devices
DO NOT use cold water on the hot glass sur-
face, the glass may shatter and injure the ope-
rator
DO NOT use rough or abrasive materials or
metal scrapers that could scratch the glass
surfaces
DO NOT use dirty cloths
gently place them on a flat surface, DO NOT
break or damage them
Action
2
DO NOT use waxes, concentrated detergents,
which contain oil, bleach, glass cleaners, abra-
sive detergents or flammable fluids
Venezia 2 TCBM-TCPW
What to avoid
3-4
English
41