Product Configuration Information Frames; Network Configuration Information Frames; Keep Alive - ADEUNIS TIC 868 Guide Utilisateur

Transceiver TIC - Guide utilisateur / User guide version V2.0.0

4.1.2 Product Configuration Information Frames

When switching to operating mode (PARC mode output) or following the reception of a downlink 0x01, the following frame (0x10) representing
the application configuration of the product is transmitted:
0 1
Code Status
0x10 Cf Status
0x10 0xA0
Description of the frame:
• Byte 2: register 300, periodicity of the frame of life, expressed in ten minutes
• Byte 3 to 4: register 301, periodicity of transmission (periodic mode), expressed in ten minutes
• Byte 5: register 306, product mode (PARC, STANDARD (production), TEST or REPLI)
• Byte 6 to 7: register 320, acquisition period
In the example in gray it gives:
• Byte 2 = 0x48: register 300, frame of life issued every 12 hours
• Byte 3 to 4 = 0x0002: the transmission will take place every 2 x S320 = 2x5 = 10 minutes
• Byte 5 = 0x01: register 306, PRODUCTION mode in progress
• Byte 6 to 7 = 0x0005: register 320, Periodic mode with an acquisition period of 5x1min = 5 minutes

4.1.3 Network Configuration Information Frames

When switching to operating mode (PARC mode output) or following the reception of a downlink 0x02, the following frame (0x20) representing
the network configuration of the product is transmitted:
0 1
Code Status
0x20 Cf Status ADR
0x20 0xA0 0x01
Description of the frame:
• Byte 2: Activation of the Adaptive Data Rate: ON (value = 1) or OFF (value = 0)
• Byte 3: Connection mode: ABP (value = 0) or OTAA (value = 1)
In the example in grey, this gives:
• Byte 2 = 0x01: Adaptive Data Rate is enabled
• Byte 3 = 0x01: OTAA connection mode

4.1.4 Keep alive

This frame (0x30) is transmitted only in the event mode to the frequency defined by the register 300.
0
Code
0x30 Cf Status
0x30
2
S300
0x48
2 3
PAYLOAD
MODE
0x01
1
Status
0xA0
3 to 4 5
PAYLOAD
S301 S306
0x0002 0x01
6 to 7
S320
0x0005
Page
FR
EN
79 of 98