Network Registers - ADEUNIS TIC 868 Guide Utilisateur

Transceiver TIC - Guide utilisateur / User guide version V2.0.0
S395 2 Low threshold hysteresis value
(S391=1,2 or 3) OR negative delta
value between data and previous data
(S391=4 or 6) on alarm 6

3.4.2 Network registers

The list of registers below allows you to change the behavior of the product application. This list is accessible in Provider mode following execu-
tion of the ATT63 Provider command.
These registers must be handled with caution because they could cause problems of communication or of non-compliance with the legislation in
force.
Registrer
S201 Spreading Factor (SF) by default
S204 Sync Word
S214 LORA APP-EUI (first part – MSB)
S215 LORA APP-EUI (second part – LSB)
S216 LORA APP-KEY (first part – MSB)
S217 LORA APP-KEY (second part – MID MSB)
S218 LORA APP-KEY (third part – MID LSB)
S219 LORA APP-KEY (fourth part – LSB)
S220 LoRaWAN Options
S221 Activation mode
Description
Decimal See register S365
Code
Decimal Default: 12 (868) or 10 (915) depending on the reference
of the product
Min/max: 4 to 12
Unit: None
Hexadecimal Default: 0x34C194C1
Hexadecimal Default: 0
Key coded on 16 characters. Each register contains part of
Hexadecimal
the key.
Used during JOIN phase in OTAA mode
For example:
APP-EUI = 0018B244 41524632
• S214 = 0018B244
• S215 = 41524632
Hexadecimal Default: 0
Key coded on 32 octet characters. Each of the 4 regis-
Hexadecimal
ters contains 8 characters.
Hexadecimal
Used during JOIN phase in OTAA mode
Hexadecimal
For example:
APP-KEY = 0018B244 41524632 0018B200
00000912
• S216 = 0018B244
• S217= 41524632
• S218 = 0018B200
• S219 = 00000912
Hexadecimal Default: 5
Bit 0: Activation of the ADR ON(1)/OFF(0)
Bit 1: Reserved
Bit 2: DUTYCYCLE ON(1)/DUTYCYCLE OFF(0)
Bit 3 to 7: Reserved
IMPORTANT NOTE:
Deactivation of the duty cycle may result in the use of the
product in a way that is not compliant with the conditions
of use of the frequency band therefore is a violation of the
regulations in force.
In the case of Duty Cycle deactivation, responsibility is
transferred to the user.
Decimal Default: 1
Choice: (see NOTE1 after the table)
• 0: ABP
• 1: OTAA
Details
Page 75 of 98
FR
EN