Invacare Matrx MX2 Back Manuel D'utilisation page 12

3.0 MX2 B
3.4 Pre-Installation: MX2 Cane Clamp Orientation: ...cont'd
WARNING! Risk of Serious Injury
When determining the final mounting position for the Invacare ® Matrx ®
MX2 back, ensure the stability of the wheelchair is not compromised.
Adjusting the fore and aft position of the backrest will alter the user's center
of gravity within the wheelchair. A recessed back position can significantly
reduce the rearward stability of the wheelchair. Similarly, amore forward back
position will reduce the wheelchair's forward stability.
MX2 Cane Clamp Orientation
Fig. 2a
1.5" (38mm)
Standard Cane
Clamp Configuration
(maximum seat depth)
3.5 MX2 Cane Clamp Installation:
The MX2 cane clamps are designed to allow installation onto 1" (25mm),
7/8" (22mm) and 3/4" (19mm) back cane diameters. (Plastic Inserts (A) are
provided to accommodate smaller diameter back canes*).
1 Remove existing wheelchair back (if applicable).
2 Loosely install the Cane Clamp Assembly (B) onto each back cane in the
desired orientation- refer to Fig. 3 and F F ig. 4 for an installation overview.
*Accomodating Different Sized Back Canes:
1" (25mm) canes - No plastic inserts required
7/8" (22mm) canes - Install 7/8" (22mm) plastic inserts (x2)
3/4" (19mm) canes - Install 3/4" (19mm) plastic inserts (x2)
- F F
ACK IXED
Front of
wheelchair
A
M I
OUNT NSTALLATION
Fig. 2b
A
1.5" (38mm)
Inverted Cane
Clamp Configuration
(minimum seat depth)
Front of
wheelchair