General Outline - BFT ORO Instructions D'utilisation Et D'installation

Thank you for buying this product, our company is sure that you will be
more than satisfied with its performance.

1) GENERAL OUTLINE

A compact sturdy hydraulic piston, available in various versions according
to the user's requirements and type of operating.
The pushing force is adjusted with extreme precision by means of two by-
pass valves which provide antisquash safety.
The end-of-stroke operation is electronically set in the control panel by
means of a timer.
2) SAFETY
If correctly installed and used, this automation device satisfies the required
safety level standards.
However, it is advisable to observe some practical rules in order to avoid
accidental problems.
• Before using the automation device, carefully read the operation
instructions and keep them for future reference.
• Keep children, people and things outside the automation working area,
particularly during its operation.
• Keep radio control or other control devices out of children's reach, in
order to avoid any unintentional automation activation.
• Do not intentionally oppose the leaf movement.
• Do not attempt to open the gate manually if:
- In mod. ORO/E the electric lock has not been released by means of
the appropriate key.
- In mod. ORO the release has not been activated by means of the
appropriate key (fig.1).
• Do not modify the automation components.
• In case of malfunction, disconnect the power supply, activate the
emergency release to have access to the automation and request the
assistance of a qualified technician (installer).
• Before proceeding to any outside cleaning operation, disconnect the
power supply.
• Keep the photocell optical components and light signal devices clean.
• Check that the safety devices (photocells) are not obscured by branches
or shrubs.
• For any direct assistance to the automation system, request the help of
a qualified technician (installer).
• Have qualified personnel check the automation system once a year.
3) EMERGENCY MANOEUVRE
3.1) Mod. ORO
In case of emergency, for example when the electrical power is
disconnected, to release the gate, insert the same key C used for the
adjustment of the by-pass valve inside the triangular pin (Fig.1) and rotate
it counterclockwise.
The gate can now be opened manually. To reset the electric operation of
the actuator, turn the key in clockwise direction until pin is blocked.
3.2) Mod. ORO/E
Since these models are reversible, for the manual operation of the gate it
is sufficient that the lock be opened with the appropriate key. To make the
manual manoeuvre easier, the lock can be released by means of a
triangular pin which can be reached using the appropriate key.
USER'S MANUAL ENGLISH
Fig. 1
ORO - Ver. 02 -
C
7