General Outline - BFT IGEA LB Instructions D'utilisation Et D'installation

ENGLISH
Thank you for buying this product. Our company is sure that you will be
more than satisfied with the product's performance. Carefully read the
"WARNINGS" pamphlet and the "INSTRUCTION BOOKLET" which are
supplied together with this product, since they provide important information
regarding the safety, installation, use and maintenance of the product. This
product complies with recognised technical standards and safety regulations.
We declare that this product is in conformity with the following European
Directives: 73/23/ EEC, 89/336/EEC, 98/37/EEC and subsequent
amendments.

1) GENERAL OUTLINE

The IGEA LB operator is suitable for motorising folding doors with a
maximum of two panels for each controller (fig.1). Two controllers are
needed for two pairs of panels. The non-reversible electro-mechanical
gearmotor maintains the stop during closing and opening.
WARNING! The installation, the maintenance and the repair should be
done by responsible and qualified persons with an updated knowledge of
the current safety standards. It's strictly forbidden to service the automation
when the power is on.
ATTENTION! The IGEA LB model controller is not equipped with mechanical
torque adjustment. It is compulsory to use a control panel of the same
manufacturer, in compliance with the basic safety requirements of directives
73/23/CEE, 89/336/CEE, 89/37/CEE equipped with appropriate electric
adjusment of the torque.
4 -
IGEA LB - Ver. 01
USER'S MANUAL
2) EMERGENCY MANOEUVRE
The emergency manoeuvre is carried out by means of a wire command,
using one of the following accessories (Fig. 2): SEB, SET/S, SIBOX-MOX.
For further information regarding their use and installation, make reference
to the instructions for the individual accessories.
Note: The knob available on this model can not be used for manual release.
It is therefore essential to install one of the wire commands mentioned
above.
WARNINGS
Correct controller operation is only ensured when the data contained
in the present manual are observed. The company is not to be held
responsible for any damage resulting from failure to observe the
installation standards and the instructions contained in the
present manual.
The descriptions and illustrations contained in the present manual
are not binding. The Company reserves the right to make any alterations
deemed appropriate for the technical, manufacturing and commercial
improvement of the product, while leaving the essential product
features unchanged, at any time and without undertaking to update
the present publication.