Transport; Storage - ATIKA BSV 315 Notice Originale

6. Open upper door and turn the band saw roll several times
manually clockwise so that the guidance rolls set in the cor-
rect positions
both guidance rolls must abut slightly on the saw band.
7. Refasten screws (M).
8. Close upper case door.
30
Adjust support roller:
1. Release locking lever (N).
2. Press support roller (O) against saw band so that it abusts
slightly on the saw band.
3. Refasten locking lever (N)
Adjusting lower band guidance
The lower band guidance consists of:
two guide pins (these guide the saw band laterally)
a support roller (this supports the saw band from behind)
Readjust the guide pins and support roller after each
saw band exchange and each saw band adjustment.
Guide pins and support roller are wearing parts. Check
these regularly and replace the pins and roller in case
of wear at the same time.
26
1. Release the 2 release handle on the bottom side of the
guidance gib (26).
2. Take off the guidance gib (26).
9
3. Release the 4 nuts and washers on the saw table guidance
(20) and take off the saw table (13).
31
Adjust guide pins:
1. Release screws (P).
2. Adjust the holder (Q) in a way that the guide pins (R) start
app. 1 mm behind the teeth ground.
3. Fasten screws (P).
4. Press guide pins (R) against the saw band.
32
5. Open upper door and turn band saw roll several times
manually clockwise that the guide pins set in the correct
position
both guide pins must abut slightly on the saw band.
6. Refasten screws (S).
7. Close upper case door.
33
Adjust support roller:
1. Release screw (T).
2. Press support roller (U) against saw band so that it abusts
slightly on the saw band.
3. Refasten screw (T).
4. Guide the table again over the saw band and screw it on at
the saw table guidance.
5. Refasten the stopper guidance profile (26).
21

Transport

Remove mains plug before each
transport.
Transport the saw only with:
− the upper saw band guidance positioned completely
downwards
− unscrewed jutting out accessories

Storage

Remove the mains plug from the socket.
Store unused equipment in a dry, locked place out of the
reach of children.
To extend the service life of the saw and guarantee smooth
operation, before storing for a longer period
− thoroughly clean the saw
− treat all movable parts with an environmentally friendly
oil
Never use any grease!