EMAK Oleo-Mac OM 92 Manuel D'utilisation Et D'entretien page 46

5.6 EMPTYING THE GRASS CATCHER
The full level of the grass catcher is signalled by the full grass catcher flap. It is possible to
regulated the full level of the grass catcher by moving the sliding part of the flap (extending
or shortening the arm).
(1) Sliding part extended = grass catcher filled to minimum
(2) Sliding part retracted = grass catcher filled to maximum
Procedure for emptying:
Drive the machine to the location where you wish to empty the grass catcher. Stop the machine and
apply the brake. If on a slope, use the parking brake.
Disengage the mowing deck by pushing down the engagement switch.
If the AUT/MAN switch is installed on the machine, leave this switch in position "AUT".
Set the throttle lever to position "MIN".
On machines with manual lifting and tilting of the grass catcher:
Slide the grass catcher lifting lever handle completely upwards (1) and tilt it down (2) to tip
out the grass catcher, allow it to empty freely, slowly release it and tilt it back.
On machines equipped with a mechanical grass catcher lifting and tilting device:
Press the grass catcher tilting switch to the position "TILT UP" and hold it down until the grass catcher
lifts all the way up. After reaching the position, release the switch and wait for the grass catcher to
empty. Then move the switch to the position "TILT DOWN" and hold it until the grass catcher tilts in
fully. When the default position is reached, release the switch.
After tilting the grass catcher down to the default position, turn on the mowing deck using the flip
switch.
46
5.6a
5.6b