Setting Up The Electronics; Dip-Switches - Burkert 1094 Instructions De Service

ATTENTION!
Carefully insert the blade of the screwdriver
under the manifold, and lever it out
(Diagram 2).
Turn the manifold to the desired position.
Insert the manifold into the housing until it
latches in.
4.2

Setting up the electronics

4.2.1 DIP-switches

Select the PWM frequency and the desired standard signal input (only applies to the
standard rail electronics Type 1094-PHR) corresponding to the listed valve types.
NOTE
8 - 1094
Only work on the equipment when all voltages have been
removed!
Ensure that the cables ends do not become twisted!
The apparatus socket may only be pushed onto the
connector flags with the fixing screw assembled.
The standard signal input must be determined before connecting
the operating voltage.
Diagram 2: Turning the manifold