Siemens SINUMERIK 840Di sl Manuel De Mise En Service page 314

Liste des fichiers INI
A.16 MBDDE.INI
; number exceeds this value, the server starts to override old
entries
; (principle: ring buffer)
Records=150
; Mode of alarm protocol writing
; if a number of less than -1 is specified, this number of protocol
files is
; parallely held, and one of them is actually used
; if a number of -1 is specified, the protocol-file is not
automatically updated
; if 0 is specified the protocol file is immediately updated
; if a number above 0 is specified, the protocol file is updated
after the
; specified number of seconds elapsed with no intermediate alarm
state
; changes. t he protocol-file is always updated when you send the
; DDE-Command: "AlarmProt" to the MBDDE-server
; (principle: ring buffer)
---------------------------------------------------------------
DiskCare=−1 # attention: the mode changed from V4 to V5 !
La stratégie multi-fichiers peut également être sélectionnée par
l'entrée DiskCare
dans le fichier Ini.
; information about the keys that may be used to clear an alarm
[KEYS]
; A function-key (e.g. ESCAPE) is assigned the cancel function.
; This makes it possible to acknowledge cancel-alarms on the
; PC development system, too.
---------------------------------------------------------------
Cancel=Escape
; This section specifies the names and paths of the help files that
; contain help texts in the WinHelp format.
; This list includes a maximum of 10 entries.
; The filename fragments must not exceed 6 chars, because it is
; extended automatically by the message module according to the
; selected language. A filename extension may be appended
optionally.
; For additional information see SINUMERIK 840D OEM package
; HMI User's Manual.
[Helpcontext]
File0=hlp\alarm_ .pdf
Pour utilisateurs OEM :
; reserve some sender names of HMI alarms. The names mbdde,
; NCU and PLC are reserved for mbdde internal purposes.
308
Manuel de mise en service, 03/2009, 6FC5397-0DP10-3DA0
HMI-Advanced (IM4)