Siemens SINUMERIK 840Di sl Manuel De Mise En Service page 310

Liste des fichiers INI
A.15 MASCHINE.INI
[Customer]
MDASingleSTEP=yes
ONLY_MKS_ToolBaseDistToGo=no
NcVersionCheck=true
; Due to performance issues the functionality offered with respect
to
; block correction, block view and block search depends on the
; Nc-version currently used.
; However, to get access to the whole functionality, regardless of
the ; Nc-Version in use,
; set the flag NcVersionCheck to False.
[BlockSearch]
; Shows (SeruproEnabled=1) or
; hides (SeruproEnabled=0)
; the softkey used to do a block search in mode "programtest".
; The softkey appears in both dialogs
; "Blocksearch Searchposition" and "Blocksearch Searchpointer"
SeruproEnabled=1
; When doing a block search in mode "programtest" you can do
; a multi-channel block search. There are 4 channel-configurations
which
; define the NC-channels being affected by the block search:
; SeruproConfig =
; 1: selected/active channel
; 2: selected/active channel and all channels having selected the
same
; workpiece as the active channel
; 3: selected/active channel and all channels belonging to the
active
; chanels's mode group
; 4: all NC-channels
SeruproConfig=1
[SetZero]
; Display_Sign_Switch switch the sign of the toollength in the
scratch picture
; Display_Sign_Switch=0 mean - toollength
; Display_Sign_Switch=1 mean + toollength
Display_Sign_Switch=1
304
Manuel de mise en service, 03/2009, 6FC5397-0DP10-3DA0
HMI-Advanced (IM4)