A.16 Mbdde.ini - Siemens SINUMERIK 840Di sl Manuel De Mise En Service

A.16 MBDDE.INI
Vue d'ensemble
Le fichier MBDDE.INI est exploité au démarrage. Les paramètres des alarmes et du fichier
journal courant dans le répertoire \mmc2 sont réglés.
[Alarme]
; determines the order in which the alarms are inserted in the alarm
list
; possible values:
; FIRST: makes newer alarms stand on top of the list
; LAST: inserts the newest alarm at the bottom
ORDER=LAST
; the alarm/message line is able to scroll the occurred alarms
; possible values:
; 0 or negative value: no scrolling
; 500 - 32767: interval in ms
RotationCycle=0
; determines if the alarm server should connect to ALARM_S/SQ or not
; possible values:
; 0 Alarm_S/SQ not handled
; 1 Alarm_S/SQ handled (default)
Alarm_S=1
; if Alarm_S/SQ handling is enabled this key determines if Quits
should
; be entered into the alarm-protocol
; possible values:
; 0 Alarm_SQ quits are not entered into the alarm protocol
;(backcompatible)
; 1 Alarm_SQ quits are entered into the alarm protocol (default)
Protocol_Alarm_SQ=1
; If Alarm_S/SQ handling is enabled this key determines if the
; workaround regarding an error in the firmware of the PLC is
; active or not. This workaround corrects the listing of
; Alarm_S/SQ in the diagnosis but causes multiple entries in
; the protocol listing of one alarm event (NEW, NULL, QUIT).
; Using a newer PLC firmware (PLC Besy Stand: S7 PLC_315 2DP
; 2AF03 12.30.03 or higher only neccessary at NCU57x.1) this
; workaround can be set inactive to correct protocol writing.
;
; Attention: Setting the workaround inactive while using an PLC
; firmware elder than 12.30.03 leads to unpredictable results!
;
; possible values:
; 0 Workaround active
; 1 Workaround inactive (default)
HMI-Advanced (IM4)
Manuel de mise en service, 03/2009, 6FC5397-0DP10-3DA0
Liste des fichiers INI

A.16 MBDDE.INI

305