A.8 Dpsim.ini - Siemens SINUMERIK 840Di sl Manuel De Mise En Service

Liste des fichiers INI

A.8 DPSIM.INI

A.8 DPSIM.INI
Vue d'ensemble
L'environnement exécutif de la simulation est défini dans le fichier DPSIM.INI.
[ACCESSLEVEL]
;minimum level for changing setup standard:
SETUP=1
UTILISATEUR=3
OPERATEUR=5
[MAIN]
;<>0: simulate program extern modal (see also
; EXTERN_SIZE,EXTERN_CHECK)
EXTERN_MODAL=0
; simulate program extern modal, if program
; size >= EXTERN_SIZE
; only if EXTERN_MODAL<>0
EXTERN_SIZE=150000
; only if EXTERN_MODAL<>0
EXTERN_CHECK=1
; <>0: reset tool data, if new workpiece is selected
; =0: use current tool data, if new workpiece is selected
SIM_LOAD_TOOLS=1
[PRELOAD]
;=1: TO_INI.INI and TO_ADDON.INI are preloaded by DPNCSIM.EXE
;=0: TO_INI.INI and TO_ADDON.INI are loaded by simulation
TOOLS=0
;= 1: all cycles are preloaded by DPNCSIM.EXE
; if section MAIN, entry CYCLE is set, additionally all cycles from
shadow directory are preloaded by DPNCSIM.EXE
;= 0: cycles are loaded by simulation, if cycle is called
CYCLES=1
;=2: load for simulation to \CUS.DIR, \CMA.DIR or \CST.DIR (default)
; load only cycles from NCK
; only evaluated if [MAIN]CYCLE is set and [PRELOAD]CYCLES=1
;=0: load all cycle (from NCK and MMC) for simulation to
; \CUS.DIR, \CMA.DIR or \CST.DIR
; only evaluated if [MAIN]CYCLE is set and [PRELOAD]CYCLES=1
;=1: use the cycle interface unter \DP.DIR\SIM.DIR
CYCLEINTERFACE=2
288
Manuel de mise en service, 03/2009, 6FC5397-0DP10-3DA0
HMI-Advanced (IM4)