Storage And Transportation; Protecting The Environment - Dewalt Dcps3382 Instructions D’origine

EnGLIsH

Storage and Transportation


CAUTION: To prevent accidental starting, always store
disconnected from the D
e
(DCPS310) or Powerpack (DCPS320).
• Install the quick-change plug cap
• Avoid exposure to rain or other precipitation. Do not
store outdoors.
• Transport the vibrator disconnected from the D
POWERSHIFT™ Backpack (DCPS310) or Powerpack (DCPS320) to
avoid heavy weight and possible tripping hazards.
Vibrator Head Lubrication
Do not disassemble vibrator head. The vibrator head is sealed at
the factory and contains a special high-performance lubricant.
Breaking the seal and adding incorrect lubricant will significantly
decrease the performance and life of the tool. If vibrator head
is damaged or needs lubricant, take the tool to a D
authorised service centre.
Cleaning

WARNING: Risk of electrical shock and mechanical
hazard. Before cleaning, disconnect from the DCPS310
or DCPS320.

WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the materials used in these parts. Use a cloth dampened
only with water and mild soap.

WARNING: DO NOT clean with a high pressure cleaner.
• Rinse the vibrator and hose with clean water from a hose.
• Rinse any dirt or debris from the quick-change plug and collar
with clean water from a hose. Allow to throughly dry before
using again.
Repairs
The vibrator contains no user serviceable parts.
Please refer to the back page of this manual for service centre
contact information, or visit www.2helpU.com.
Optional Accessories

WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
e
accessories with this tool could be hazardous. To reduce the risk
of injury, only D WALT-recommended accessories should be used
e
with this product.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Products/batteries are recyclable, but if marked with the
crossed-out bin, they must not be disposed of with normal
household waste.
Run the batteries down completely and separate them, and
separate any light sources from the product if possible. It
is the user's responsibility to delete personal data from the
product. Then take the waste to an official waste collection
center or a participating retailer who will often accept it free of
charge. Packaging should be discarded based on the marked
18
WALT POWeRSHIFT™ Backpack
4 onto the quick-change plug
WALT
e
WALT
e
material code. Operating and safety instructions should only be
discarded once the applicable product is no longer in use.
Please check with your local community/municipality for
waste management guidance. For further information, visit
www.2helpU.com and scan the above QR code.
3 .