DeWalt DXDP110001 Manuel D'utilisation page 8

English
WARNING:
Do not use this device for towing
objects.
WARNING:
When using tool lanyard and
accessories, basic precautions should always be
followed, including the following:
WARNING:
Keep the lanyard and wrist strap
clean and free of debris. Clean with a damp cloth
and mild soap, wipe off excess and thoroughly dry.
Do not use solvents.
INSPECTION
a ) A visual inspection is essential before using any
D WALT equipment.
E
b ) Before each use, make sure you find no signs of cuts,
wear, discoloration, corrosion, etc. When in doubt, the
equipment should be replaced.
c ) Do not use this equipment beyond its weight limit.
d ) Always check the connection before each use.
e ) Tool lanyard that has been used to arrest a falling
tool should be taken out of service.
f ) Do not alter or use in a manner other than as
instructed in this manual.
12
WARNING:
Do not attempt to disassemble the
unit or make repairs to the equipment. Send the
equipment back to the manufacturer, or person or
entities authorized in writing by the manufacturer
to make repairs to the equipment.
MAINTENANCE AND CLEANING
a ) Proper care is important for maintaining the
safety and longevity of the tool lanyard. Before and
after each use, remove all dirt, corrosives, and other
contaminants from the D WALT Tool Lanyard.
E
b ) Do not wrap lanyard around sharp or rough edges.
Tool lanyard should not be used with blades, knives,
etc.
WARNING:
The user must weigh the tool to be
tethered to ensure they do not exceed the maximum
safe working capacity of the tool lanyard or any
part of the tethering system. User should also refer
to the label or user manual for information on
maximum capacity.
WARNING:
After every use or if the tool
lanyardhas arrested a tool fall, the tool lanyard
should be checked by a competent person. If
deemed not fit for use, it should be immediately
removed from use.
STORAGE AND TRANSPORTATION
a ) When not in use, store equipment where it will not be
affected by heat, light, excessive moisture, chemicals,
or other corrosive elements.
b ) The product should be kept and transported in its
original packaging or in airtight packaging.
DISPOSAL
a ) If any wear or damage is observed, the product
must be removed from service and destroyed. Using
scissors, cut the textile to dismantle it.
English
WARNING:
Whatever combination you use,make
sure that it does not interfere with the safe use of
the tool.
LIFESPAN: The estimated product Lifespan depends if the
product passes the pre use inspection and periodic inspection
by competent person. The following factors can reduce the
Lifespan of the product: intense use, contact with chemical
substances, especially aggressive environments, extreme
temperature exposure, UV exposure, abrasions, cuts, violent
impacts, bad use or maintenance.
DISCLAIMER: Prior to use the end user must read and
understand the manufacturer' s instructions supplied with
this product at the time of shipment and seek training from
their employer' s trained personnel on the proper usage of the
product. Manufacturer is not liable or responsible for any loss,
damage or injury caused or incurred by any person on grounds
of improper usage or installation of this product.
PRODUCT LABEL
Product label has the following information:
a ) Manufacturer's logo g ) Serial number
b ) Product category h ) Batch number
c ) Product name i ) Date of manufacture
d ) Model number j ) Load capacity
e ) Material of construction k ) Relaxed length
f ) Relevant standards l ) Max. expanded length
13