Telcoma T600 Notice D'emploi page 51

4a
M1
4b
M1
5
M1
6a
M1
6b
M1
6c
M1 FINE PROG.
EVOLVED programming
DIP 9 set to OFF during programming: Deceleration times will NOT be modified.
DIP 9 set to ON only after programming: Default deceleration times will be set.
DIP 9 set to ON during programming: the ECU is ready to receive personalised deceleration values.
You do not have to set all the values.
7a
M1
7b
M1
7c
M1
8
M1
STANDARD programming
After having found the M1 closing travel limit it will open automatically.
M2
When the gate with M1 finds the opening travel limit, the other motor M2 will begin
to move.
M2
When the gate with M2 has opened completely (reaching the mechanical stop),
pause time memorisation will start (if automatic reclosing is not being used you
may move directly to point (6a).
M2
Once the desired pause time has elapsed, press button P/P and motor M2 will
begin to close.
M2
When the gate with M2 has found the closing travel limit, the other motor M1 will
begin to close.
M2
When the gate with M1 has closed completely, the motor will stop, led LD1 will
switch off and the ECU will quit programming
Checks: force, times and stopping points. We advise you to consider inserting
deceleration points (DIP 9 set to ON) to reduce impact against the travel limits so
reducing wear and tear on the mechanical parts.
M2
Repeat programming if you have modified the mechanical travel limits.
After point 3e the gate with M1 will start to open.
Press P/P when M1 has reached the desired gate delay angle, the motor will stop
for a second and then continue the opening cycle.
After this point we can manually insert the DECELERATION start points
using P/P (DIP 9 set to ON) the motor will stop for a second then start again.
M2
Otherwise wait until the gate reaches the travel limit.
M2
When the gate with M1 has opened completely, the motor will stop and the other
motor (M2) will start to move automatically.
After this point we can manually insert the DECELERATION start points
using P/P (DIP 9 set to ON) the motor will stop for a second then start again.
Otherwise wait until the gate reaches the travel limit.
M2
When the gate with M2 has opened completely (reached the travel limit), the motor
will stop and the pause time memorisation will start (if automatic reclosing is not
being used you may move directly to point (6a).
M2
GB
50